Panel Programming

• Default Keypad Login code = 1111
• 1) Login to panel
• 2) [FULL ENGINEER] will be displayed.
• 3) Press [SELECT] button. [SYSTEM STATUS] will be displayed.
• 4) Scroll down menu until [COMMUNICATION] is displayed and press [SELECT].
• 5) Scroll down menu until [MODEMS] is displayed and press [SELECT].
• 6) [PRIMARY] is displayed. Press [SELECT].
• 7) [ENABLE MODEM] is displayed. Press [SELECT] to set modem to be enabled.
• 8) Scroll down menu until [COUNTRY CODE] is displayed and press [SELECT] to set to UK.
• 9) Scroll down menu until [ANSWER MODE] is displayed and press [SELECT] to set to numbered rings of 1 ring.
• 10) Scroll down menu until [LINE MONITORING] is displayed and press [SELECT] to set mode to disabled.
• 11) Press the [BACK] button until [PRIMARY] is displayed.
• 12) Scroll down menu until [BACKUP] is displayed and press [SELECT] to disable the backup modem.
• 13) Press the [BACK] button until [MODEMS] is displayed.
• 
  14) Scroll down menu until [CENTRAL STATION] is displayed and press [SELECT].
  
• 15) [ADD] will be displayed. Press [SELECT] to create a new Central Station account.
• 16) Input account ID and press the [ENTER] button. (Press and hold key for number input)
• 17) Input account name and press the [ENTER] button.
• 18) Select [SIA] as the protocol to use and press [SELECT].
• 19) Input the 1st Phone number and press the [ENTER] button.
• 20) Clear 2ndPhone number and press the [ENTER] button.
• 21) Press the [BACK] button until [CENTRAL STATION] is displayed.
• 22) Scroll down menu until [REMOTE MAINT.] is displayed and press [SELECT].
• 23) Enable Remote Maintenance.
• 
  24) Scroll down menu until [ID] is displayed and press [SELECT].
  
• 25) Input ID.
• 26) Scroll down menu until [PASSWORD] is displayed and press [SELECT].
• 27) Input password.
• 28) Scroll down menu until [IN CONN. SETTS.] is displayed and press [SELECT].
• 29) Disable IP.
• 30) Press back until [REMOTE MAINT] is displayed
• 31) Scroll down menu until [SPC Pro] is displayed and press [SELECT].
• 32) Enable access, input ID and passwords.
• 33) Disable IP.
• 34) Press [BACK] until no longer in engineer mode.

Remote Access Programming

• Go to ‘set up downloading’
• Select download by (WebWayOne)
• Select poll timeout <10>
• Select modem init timeout <060>
• Select rings to answer <1>
• Select comm. Tx timeout <030>
• Select ARMPC telephone number (not required)
• Select program PCs <1>
• Select modem telephone number (not required)
• Select signal alarms (No)
• Select signal faults (No)
• Select signal set/unset (No)
• Select signal access code (No)
• Select password (optional UDL password)
• Select redials <03>

• Select time out <00>
• Select stop on success (No)
• Select dial mode (retry same)
• Exit engineering mode and save the configuration

UDL information for this item can be found here: