Panel Programming

• Digicom SIA and Triggers:
• 1. Press [1][2][3][4][YES] to get into Engineer mode (If prompted also enter the authorise code)
• 2. If prompted ‘Do you want to use engineer mode - enter [Yes]
• 3. Press [3][4][YES] to jump to Digicom
• 4. Press [NO] until you see ‘Mod + SIA’
• 5. Press [YES]
• 6. Press [0]
• 7. Press [NO] until you see ‘Channels’
• 8. Press [YES][YES] (To change channels/triggers)
• 9. Press [NO] once
• 10. Press [YES] until the “>” appears next to PA
• 11. Press [NO] to change the ‘Off’ to ‘On’
• 12. Press [YES][YES]

• 13. Press [0] repeatedly to get out of Engineer mode

• Digicom switching ON and Entering phone number:
• 1. Press [1][2][3][4][YES] to get into Engineer mode
• 2. Press [3][4][YES] to jump to Digicom
• 3. Press [0] (go back)
• 4. Press [NO] until you see ‘Functions’
• 5. Press [YES]
• 6. Press [NO] until you see ‘Comms Functions’
• 7. Press [YES]
• 8. Press [NO] until you see ‘Comms=On’
• 9. Press [YES]
• 10. Press [NO] and key in the required Site Code/Id
• 11. Press [YES]
• 12. Press [NO] and key in the required ARC telephone number
• 13. Press [YES]

• 14. Press [0] repeatedly to get out of Engineer mode

• Set Line Monitor to low security:
• 1. Press [1][2][3][4][YES] to get in to engineer mode.
• 2. Press [3][4][YES] to jump to Digicom
• 3. Press [0] (go back one menu place)
• 4. Press [NO] till you see 'Functions'
• 5. Press [YES]
• 6. Press [NO] till you see 'Comms Functions'
• 7. Press [YES]
• 8. Press [YES] till you see 'Line Monitor'
• 9. Press [NO] till you see 'Line Volts'
• 10. Press [YES]
• 11. Press [[NO] till you see 'Line Security'
• 12. Press [NO] until ‘Low’
• 13. Press [YES
• 14. Press [0] multiple times to get out of engineer mode

Set modem for UDL connectivity:

• Press [1][2][3][4][YES] to get in to engineer mode.
• Press [3][4][YES] to jump to Digicom
• Press [0] (go back one menu place)
• Press [NO] till you see 'Functions'
• Press [YES]
• Press [NO] till you see 'Program Modem Functions'
• Press [YES]
• Press [NO] till you see ‘Modem Mode’
• Press [NO] till ‘No Return’ is selected.
• Press [YES].
• Next you will see ‘Double Ring’
• Press [NO] until ‘Off’ is selected.
• Press [YES] until ‘Site ID code’
• Press [NO] and insert Site\account number
• Press [YES] and you will see ‘Password’

• Press [NO] and insert password
• Press [YES] and you will see ‘Phone number 1’
• Press [NO] and insert any telephone number
• Press [YES] until you see ‘Modem Access’
• Press [NO] until ‘Any Time’ is selecte
• Press [YES]
• Press [0] multiple times to get out of engineer mode

UDL information for this item can be found here: