Panel Programming

• Engineer login and set-up: 1. Press *8
• Keypad displays ‘Enter Your Installer Code’ > Press 5555
• Scroll to (00) System Area and press *
• Scroll to (03) DLS Section and press *
• Scroll to (00) DLS Toggles and press *
• Set DLS Enabled = Y > Press # twice
• Scroll to (04) Communicator and press *
• Scroll to (00) Main Items and press *
• Scroll to (00) 1st Number and press *
• Scroll to (00) Pgm Tel Number and press *

• Set to 01234 567890

• Scroll to (01) Comms Format and press * > Set to SIA Fsk Format
• Scroll to (02) Dialer Direction and press *
• Toggle events to be sent > Press # twice.
• Scroll to (03) System Account and press *
• Set Account Code, normally same Site ID as SPT

• Press # until you are back to step 9

• Scroll to (01) Communications options and press *
• Set Communicator Enabled = Y
• Set TLM Enabled = N
• Set Automatic SIA codes = Y
• Set TLink Enabled = N

Remote Access Programming

• Go to set up downloading۪
• Select download by
• Select security mode
• 4. Select telecom line
• Select number of rings <3>
• Select modem speed
• Select ARMPC telephone number <123456>
• Select program PCs <1>
• Select modem telephone number (not required)
• Select signal alarms (No)
• Select signal faults (No)
• Select signal set/unset (No)
• Select signal access code (No)
• Select password (optional UDL password)
• Select redials <03>

• Select time out <00>
• Select stop on success (No)
• Select dial mode (retry same)
• Exit engineering mode and save the configuration
• Go to Site Options
• Select ATE inputs

UDL information for this item can be found here: