Panel Programming Steps

• 1) Engineer login and set-up: 1. Press *8
• 2) Keypad displays ‘Enter Your Installer Code’
• 3) Press 5555
• 4) Scroll to (00) System Area and press *
• 5) Scroll to (03) DLS Section and press *
• 6) Scroll to (00) DLS Toggles and press *
• 7) Set DLS Enabled = Y
• 8) Press # twice
• 9) Scroll to (04) Communicator and press *
• 10) Scroll to (00) Main Items and press *
• 11) Scroll to (00) 1st Number and press *
• 12) Scroll to (00) Pgm Tel Number and press *
• 13) Set to CAAA and remove ‘D’ from the beginning
• 14) Scroll to (01) Comms Format and press *
• 15) Set to SIA Fsk Format
• 16) Scroll to (02) Dialer Direction and press *
• 17) Toggle events to be sent.
• 18) Press # twice.
• 19) Scroll to (03) System Account and press *
• 20) Set Account Code, normally same Site ID as SPT
• 21) Press # until you are back to step 9) and clear 2nd and 3rd telephone number, then step 22)
• 22) Scroll to (01) Communications options (CommsToggles) and press *
• 23) Set Communicator Enabled = Y
• 24) Set TLM Enabled = N
• 25) Set Automatic SIA codes (AutoReport SIA) = Y
• 26) Set TLink Enabled = Y

Remote Access Programming

• Go to set up downloading۪
• Select download by (WebWayOne)
• Select poll timeout <10>
• Select modem init timeout <060>
• Select rings to answer <1>
• Select comm. Tx timeout <030>
• Select ARMPC telephone number (not required)
• Select program PCs <1>
• Select modem telephone number (not required)
• Select signal alarms (No)
• Select signal faults (No)
• Select signal set/unset (No)
• Select signal access code (No)
• Select password (optional UDL password)
• Select redials <03>

• Select time out <00>
• Select stop on success (No)
• Select dial mode (retry same)
• Exit engineering mode and save the configuration

UDL information for this item can be found here: