Serial Connectivity PC1616 / PC1832 / PC1864 Configuration

• Engineer login and set-up: Press *8
• Keypad displays ‘Enter Your Installer Code’ > Press 5555
• Keypad displays ‘Enter Section’ > Press 015
• Keypad displays ‘Toggle Option’ followed by’ 8 ‘ (This may have some set to numbers. If 7 is displayed, press 7 to remove it from the display. This disables Telephone line monitoring).
• Press # > Press 301
• Keypad displays may display some numbers and letters followed by lots of F’s Replace with ‘DCAA’ followed by all F’s. This adds TLink to route calls to.
• Press # > Press 302 and do the same as in 301 but fill all with F’s. This will clear all possible telephone numbers
• Press 350 > Keypad displays ‘Enter Data’
• Press 04 then a moment later 04 again. This sets up alarms to be reported in SIA.
• Press 380 > Keypad displays ‘Toggle Option’ followed by 8 this may have some numbers set. If 1 is not displayed, press 1 to add it to the display. This enables the system communicator.
• Press # > Press 381
• Keypad displays ‘Toggle Option’ followed by 8 this may have some numbers set. If 3 is displayed, press 3 to remove it from the display. This disables Automatic SIA codes.
• Press # > Press 382
• Keypad displays ‘Toggle Option’ followed by 8 this may have some numbers set. If 5 are not displayed, press 5 to add it to the display. This enables TLink communications.
• Press # > Press 401
• Keypad displays ‘Toggle Option’ followed by 8 this may have some numbers set. If 1 is not displayed, press 1 to add it to the display. This enables UDL communications to the DLS application.
• Press #

Remote Access Programming

• Go to set up downloading۪
• Select download by (WebWayOne)
• Select poll timeout <10>
• Select modem init timeout <060>
• Select rings to answer <1>
• Select comm. Tx timeout <030>
• Select ARMPC telephone number (not required)
• Select program PCs <1>
• Select modem telephone number (not required)
• Select signal alarms (No)
• Select signal faults (No)
• Select signal set/unset (No)
• Select signal access code (No)
• Select password (optional UDL password)
• Select redials <03>

• Select time out <00>
• Select stop on success (No)
• Select dial mode (retry same)
• Exit engineering mode and save the configuration

UDL information for this item can be found here: