Requirements

WebWayOne Modem Capture Module
SPT Firmware V3.47 or greater
Remote Manager V3.2.2.4 or greater

WebWayOne Guide -  

Siemens Guide Siemens Guide (490 KB)


SPT Fitting



WebWay Modem Capture Siemens Modem Capture


Connect the WebWay PWR + and - to any relevant Power (+12V/+24V) and Ground (0V) terminals and a modem capture connection as follows,

WebWay Modem Cpature

 Siemens (PC137421 MCM Unit)

A

A

B

B


Panel Programming 

Default Keypad Login code = 1111

1) Login to panel

2) [FULL ENGINEER] will be displayed.

3) Press [SELECT] button. [SYSTEM STATUS] will be displayed.

4) Scroll down menu until [COMMUNICATION] is displayed
and press [SELECT].

5) Scroll down menu until [MODEMS] is displayed and press [SELECT].

6) [PRIMARY] is displayed. Press [SELECT]. 

7) [ENABLE MODEM] is displayed. Press [SELECT] to set modem
 to be enabled.

8) Scroll down menu until [COUNTRY CODE] is displayed 
and press [SELECT] to set to UK.

9) Scroll down menu until [ANSWER MODE] is displayed 
and press [SELECT] to set to numbered rings of 1 ring.

10) Scroll down menu until [LINE MONITORING] is displayed
 and press [SELECT] to set mode to disabled.

11) Press the [BACK] button until [PRIMARY] is displayed.

12) Scroll down menu until [BACKUP] is displayed and
 press [SELECT] to disable the backup modem.

13) Press the [BACK] button until [MODEMS] is displayed.

14) Scroll down menu until [CENTRAL STATION] is displayed
 and press [SELECT].

15) [ADD] will be displayed. Press [SELECT] to create a new 
Central Station account.

16) Input account ID and press the [ENTER] button.
(Press and hold key for number input)

17) Input account name and press the [ENTER] button.

18) Select [SIA] as the protocol to use and press [SELECT].

19) Input the 1st Phone number and press the [ENTER] button.

20) Clear 2ndPhone number and press the [ENTER] button.


21) Press the [BACK] button until [CENTRAL STATION] is displayed.

22) Scroll down menu until [REMOTE MAINT.] is displayed
 and press [SELECT].

23) Enable Remote Maintenance.

24) Scroll down menu until [ID] is displayed and press [SELECT].

25) Input ID.

26) Scroll down menu until [PASSWORD] is displayed
 and press [SELECT].

27) Input password.

28) Scroll down menu until [IN CONN. SETTS.] is displayed 
and press [SELECT].

29) Disable IP.

30) Press back until [REMOTE MAINT] is displayed

31) Scroll down menu until [SPC Pro] is displayed and press [SELECT].

32) Enable access, input ID and passwords.

33) Disable IP.

34) Press [BACK] until no longer in engineer mode.